Pilot wire technology

Embedded programming

Embedded programming works in the following manner: the control module is carried by the heating appliance and, for pilot wire control, only one appliance is fitted with the programming system.

This simple and economical type of programming enables you to create heating zones, for example, one day zone (living room, lounge, kitchen) and one night zone (bedrooms, etc.). The bathroom can be a third zone (see Chronopass only in the renovation offering).

In each of these zones, a heat emitting appliance gives orders to the other appliances in the zone and all the appliances are set to the programming mode.

1. Stop
2. Frost-free mode
3. Program settings
4. Eco mode
5. Comfort mode

Overrides on the appliance cursors enable the heating mode to be changed appliance by appliance when necessary (e.g. for a poorly child, the bedroom emitter is set to comfort mode instead of the usual programming mode).

The programming can be made on one appliance (individual) or a group of appliances (heating zone).

The relevant unit is the pilot wire interface.

1) Pilot wire interface kit

The pilot wire interface kit includes the pilot wire interface + the Chronopass

A) Pilot wire interface

Attached to the back of the emitter that controls the other appliances in a zone, it communicates with the other appliances.

B) Chronopass:

This device is installed in the interface and is used for the weekly programming, hour by hour with 3 programs available. 1 Chronopass is required per heating zone. Initially, there are 3 programs set in the factory that can be changed according to individual requirements.

1.Program no.1 display
2.Displays the days assigned to program no.1
3.Programs no.2 and 3 button
4.Navigator
5.Modification button
6.Confirmation button